1. The centrifugal concept is based on the principle of the pump. The centrifugal pump is a pump divided from the working principle. It is the process of pressurizing the conveying medium through the action of centrifugal force. After completing the concepts of centrifugal pump and slurry pump, the slurry pump is divided from another perspective, that is, from the perspective of conveying medium.
2. The main working parts of the centrifugal pump are the impeller and the casing. The impeller device in the casing is located on the shaft and connected to the prime mover to form a whole. When the prime mover drives the impeller to rotate, the blades in the impeller force the fluid to rotate, thereby increasing the pressure potential energy and kinetic energy of the fluid. Under the action of inertial force, the fluid flows from the center of the impeller to the edge of the impeller, flows out of the impeller at high speed, enters the extrusion chamber, and then is discharged through the diffuser. This process is called the water pressure process. At the same time, because the fluid in the center of the impeller flows to the edge, a low-pressure area is formed in the center of the impeller. When there is enough vacuum, under the action of the suction end pressure (generally atmospheric pressure), the fluid enters the impeller through the suction chamber. This process is called the water absorption process. Due to the continuous rotation of the impeller, the fluid will be continuously discharged and inhaled, forming a continuous operation.
3. The working process of a centrifugal pump (including a slurry pump) is actually a process of energy transfer and conversion. It transfers the mechanical energy of the high-speed rotation of the motor through the pump blades and converts it into the pressure energy and kinetic energy of the pumped fluid.
