The trial operation of the slurry pump should meet the following requirements:
(1) The direction of the drive motor should be the same as that of the pump;
(2) There should be no looseness in the fixed connection parts, and the specifications and quantity of lubricants added to the lubricating parts should comply with the provisions of the equipment technical file;
(3) Parts with pre-lubrication requirements should be pre-lubricated as required;
(4) All indicating instruments and safety protection devices should be sensitive, accurate and reliable;
(5) The turning gear should be flexible and free of abnormal phenomena;
(6) The high-temperature pump should be preheated before the trial operation, and the temperature should rise evenly. The temperature rise per hour should not be greater than 500%; the temperature difference between the pump body surface and the process pipeline with the working medium inlet should not be greater than 400℃;
(7) A connection device should be set to eliminate the influence of temperature rise, and a bypass connection device should be set to provide cooling water source.
The following points should be noted when operating the slurry pump:
(1) Do not operate without water, do not adjust the suction port to reduce the displacement, and do not operate at too low a flow rate;
(2) Monitor the operation process, completely prevent the leakage of the stuffing box, and use new stuffing when replacing the stuffing box;
(3) Ensure that the mechanical seal has sufficient water flow to flush, and do not use excessive water flow for water-cooled bearings;
(4) Do not use too much lubricant;
(5) Check according to the recommended cycle; establish operation records, including operating hours, adjustment and replacement of stuffing, addition of lubricant and other maintenance measures and time; the suction and discharge pressure, flow, input power, temperature of the washing liquid and bearings, and vibration of the centrifugal pump should be measured and recorded regularly.
Slurry Pump Commissioning And Operation
Jun 05, 2025
Leave a message
